The “Rendiconti Online della Società Geologica Italiana” are published in quarterly volumes. The size of each volume is 21 × 29,7 cm (A4) and the printed portion is 18,5 × 4,4 cm, in two columns of 9 × 24,4 cm.
All Authors may submit to the journal original scientific contributions, both in Italian and English, concerning all aspects of geosciences. The instructions described below should be strictly followed by the authors. The non-compliance with these instructions may delay or prevent publication. Text and figures accepted for publication are copyright of the journal.
The Rendiconti Online host two types of contributions: “short notes” and “articles”.
Short notes - These are short reports (6 to 8 pages, including four figures or tables and no more than 30 references). Short notes must follow the usual structure of a scientific contribution (introduction, materials & methods, results, discussion, conclusions), and will follow a peer-reviewing process (2 reviewers).
Articles - These are original research peer-reviewed papers (2 reviewers). They should not exceed 15 printed pages, including references, figure/tables and captions. There are no limits for the number of figures/tables and references, even if it should be in due proportion with the length of the text.
The organisers of workshops, conferences, scientific meetings and sessions of meetings, etc., should submit a proposal of a special/thematic issue to the Editor in Chief (EiC) of ROL; special/thematic issues consist of short notes only. The proposal should include i) names of possible Guest Editors (GE), ii) aim of the special/thematic issue, iii) list of contributors, iv) list of contributions, including the list of authors and title for each contribution.
The EiC and the board of Associate Editors (AE) will take under consideration the submitted proposal and will reply to the proponents within 30 days, informing them about the acceptance/denial of the special/thematic issue and providing the name of the Associate Editor (AE), who will take the scientific responsibility of the contributions published in the special/thematic issue.
Once the special/thematic issue is accepted, the GE make the call for papers to the invited authors setting a deadline for the contribution submission, then decide the name of the peer reviewers and commit possible revisions to be made. Final responsibility to accept/deny publication of each manuscript will be taken by the AE.
As a general rule for special/thematic issues, a single author may have up to a maximum of two papers.
Manuscripts must be submitted in digital format, as per the following instructions.
The text may be in English or Italian. It is, however, recommended to adopt English language to enable and promote a wider dissemination of the contributions. Manuscripts written in Italian should have an extended abstract (1500-2000 characters).
The manuscript, including references and figure captions, must be double spaced and prepared using a ‘standard’ font, preferably 12-point Times New Roman; line numbers must be added. For mathematical symbols, Greek letters and other special characters, use normal text or Symbol font. Word Equation Editor/MathType should be used only for formulae which cannot be produced using normal text or Symbol font.
An uninterrupted page of text contains about 1,100 words. When considering final length of short notes or articles, authors have to consider that a full-page figure/table is equivalent to about 1,100 words, a half-page figure/table to about 500/600 words and so on.
When submitting new or revised manuscripts, authors should state in a cover letter to the editor their rough estimate of the length of their paper in terms of number of pages of ROL. Authors of contributions that significantly exceed the limits stated here or specified by the editor will have to shorten their papers before acceptance, inevitably delaying publication.
Submit the text in the following order: Title, authors' names and addresses, telephone, fax and e-mail of the corresponding author. Below abstract/riassunto (max 1000 characters for short notes), key words/parole chiave, text, acknowledgements, references. Figures, captions and tables should be provided separately but with their position within the text indicated appropriately, using the format provided below.
Authors must observe a correct usage of stratigraphic terminology, avoiding the citation of incorrect or abandoned stratigraphic names. Web sites and publications such as the International Chronostratigraphic Chart, the International Stratigraphic Guide, the Italian Stratigraphic Guide, and the Catalogue of the Italian geological formations, are recommended as initial sources of stratigraphic information.
References should be inserted in parentheses in the text in full for single- and dual-authored papers (e.g. Lyell & Bertrand, 1987), but using first author and “et al.” for multiple-authored papers (e.g. Lyell et al., 1988). Authors should be written with uppercase initials. The order in the text should be chronological, then alphabetical. List all references cited in alphabetical order at the end of the article in the following standard form:
Baker V.R. (2006) - Water and the evolutionary geological history of Mars. Boll. Soc. Geol. It., 125, 357-369.
Article in volume
Martini I.P., Sagri M. & Colella A. (2001) - Neogene-Quaternary basins of the inner Apennines and Calabrian arc. In: Vai G.B. & Martini I.P. (eds.), Anatomy of an Orogen: The Apennines and Adjacent Mediterranean Basins. Kluwer Academic Publisher, 375- 400.
Ramsay J.G. & Huber M. (1987) - The techniques of Modern Structural geology. Volume 2: Folds and Fractures. Academic Press, London, 500 pp.
Ghinassi M. (2000) - Il passaggio tra la prima e la seconda fase fluvio-lacustre del bacino del Valdarno Superiore nei pressi di S. Giovanni Valdarno. Unpublished Master thesis, University of Florence, 110 pp.
Servizio Geologico d'Italia (2011) - Carta Geologica d'Italia alla scala 1:50.0000, F. 99 Iseo. ISPRA, Roma.
Explanatory notes of geological maps
Pantaloni M., Pichezzi R.M., D'Ambrogi C., Pampaloni M.L., Rossi M. (2016) - Note Illustrative della Carta Geologica d'Italia alla scala 1:50.000, F. 280 Fossombrone. 96 pp., S.EL.CA. Firenze.
Please use the standard abbreviation of a journal’s name according to the ISSN List of Title Word Abbreviations: http://images.webofknowledge.com/images/help/WOS/A_abrvjt.html. If you are unsure, please use the full journal title.
Please use a maximum of three levels of headings, hierarchically arranged as outlined below.
Capital letters, centered, bold.
The first sentence after the heading begins after a blank line.
SECOND ORDER HEADINGS
Capital letters, left margin.
The first sentence after the heading begins after a blank line.
Third order headings
Italic, left margin. The first sentence after the heading begins after a blank line.
Footnotes are not allowed.
All abbreviations used in the text must be clearly explained the first time they appear.
The maximum available space for an illustration is 185×244 mm (full page) or 90×244 mm (column). Figures should be prepared with lettering and symbols of sufficient size and clarity to be reduced (Arial, 6-8 pt. minimum). After reduction, the smallest lettering should be a minimum of 2 mm high. Figures should be provided as .tif or .jpg format (at least with a resolution of 500dpi). Tables can be submitted as .xls or .doc files. Figures in the text must be quoted as fig. or figs., plates as pl. and tables as tab. (tabs). It is the responsibility of the authors to ensure that permission is granted for reproduction of any copyright material (reproduced figures, tables, text passages) and that this permission is acknowledged in their articles.
The corresponding author will receive a single copy of the proof in PDF format. PDF proofs can be annotated using Adobe Reader DC. The proof must be sent after correction to the Editors within five days. Text or figure changes can be also listed in a .doc file.